In the early 1990’s Badger Ordnance identified the need for quality Tactical scope rings and mounts designed to meet the higher demands of the emerging Military and Law Enforcement tactical shooting community. The Maximized series of Scope Rings and Rails are made to the highest tolerances in the industry. Badger Scope Rings are machined from steel barstock as serialized matched pairs. This assures that both rings are identical and eliminates the damaging effects of mismatched mass produced rings. Maximized rings are designed to fit MIL STD 1913 (also called Picatinny) optical rails and are finished with Mil Spec Parkerizing. All the hardware on Badger rings are designed by Badger. MAX-50 Rings are made to the same specifications as our standard rings but are 1 INCH wide! The MAX-50’s have 60% more holding power and were designed specifically to tame the recoil of the .50 BMG Six 8-40 Torx- screws secure each scope cap to the ring. Maximized Scope Rail This Picatinny spec. one piece mount is machined from 4142 prehardened (28-32Rc) steel. With its integral recoil lug, a Mil-Std-1913 slot is pattern for more mounting options and a 20 MOA forward cant for extended range. Compatiable with Badger’s Maximized rings or any Picatinny ring. Mil. Spec. Black Parkerizing. Maximized Lugged Scope Rail Bottomed lugged for clip slotted actions only. This Picatinny one piece mount is machined from 4142 pre-hardened (28-32Rc) steel. With a Mil-Std-1913 slot pattern for more mounting options and a 20 MOA forward cant for extended range. Compatiable with Badger’s Maximized rings or any Picatinny compatible ring. These are 1/2" longer for night vision options. Downloads: Installing Bases and Rings Installing Bases and Rings (diagram) (PDF)